Curly Winter Wreath

Supplies Needed:
Designer series paper 8- 12×12 sheets
Straight pins with flat heads
114 inch foam core wreath, the hard foam
White ribbon 24 inches
Hot glue gun and glue
3 sheets of whisper white card stock
Frosted finishes embellishments
Festive flurry stamp set and dies
Apothecary accent dies
Sticky strip
Snow day stamp set
1 sheet Marina mist card stock
Score board

Cut 1/2 inch strips of designer series paper out of all 8 sheets


Then take your bone folder and curl paper from the middle on both end. Wrap around pencil and fluff out


Then cut 9 strips of whisper white card stock at 1 1/2 x8 1/2
Score all of them at 1/2 with the 8 1/2 side at the top
Fold all score lines back and forth
Sticky strip all four ends together to form a circle
Put on a mat and hot glue the center and put on a 1/2 circle on both sides, to form the rosette.
Repeat this 2 more times
Hot glue to wreath we’re desired
And hot glue and pin ribbon to the top
Stick a streat pin through center of the curl and paper and attach to foam wreath.


Cover all of the wreath except for the back which will be covered when hung.
Stamp 2 smallest snow flakes onto white and run through the big shot with the smallest festive flurry die.
Die cut 2 of the next biggest snow flakes out of marina mist.
Put stamped snowflake onto larger one and sticky strip to the rosette.
Put on the two lower rosettes and then add frosted finishes embellishment
Stamp snow day stamp set on whisper white and cut out, as seen in picture below.
Add dazzling diamonds to snowman and then die cut a piece of marina mist from the apothecary frame lets set, the large one.
Place the snowman on the cut out then add to the rosette.

Enjoy Brenda


Share this:

Speak Your Mind